TAI Talmora Diamond Inc

Talmora Diamond Inc. (CNSX:TAI) is pleased to report the analytical work
completed on cuttings from Packsack drill holes completed in 2012. The Packsack
drill, rated for depths of up to 100', was used to sample and test the thickness
of overburden over 4 magnetic anomalies in dolomite bedrock. Three of five holes
penetrated glacial overburden and ended in rusty brown (lateritized?) clay,
containing fragments of dolomite. Core could not be recovered and the cuttings
have lost much of their fine fraction.


The magnetic anomalies have been deeply scoured by ice and are covered by
bouldery till, which in turn is overlain by various thicknesses of lake
sediment. Cuttings of the till and clay beneath three of the holes were
chemically analysed and concentrates were examined for kimberlite indicator
minerals (KIMs).


Chemical analyses of the till cuttings show a 80-90% loss of Ca & Mg (dolomite)
and lesser amounts of Al, Fe, Mn, Ti, K, Na and P (probably chlorite, limonite,
mica) compared to the average till in the area. There is a 45% increase in Si
(quartz sand) probably resulting from the loss of the above elements in fines.


The clay cuttings compared to the till cuttings show slightly higher values for
all major elements except Si. The Si is still high in the clay cuttings
indicating probable contamination from the overlying till as the clay section
had to be re-drilled after each run because the hole collapsed. If the clay is
weathered kimberlite a depression is expected to have formed above it and if it
is of pre-Cretaceous age the depression may have been filled by Cretaceous
marine sand. Almandine garnets in the clay cuttings also indicate contamination.


Compared to the till cuttings the clay cuttings have elevated values of minor
elements. There is twice as much Cr and Mo; three times as much Fe, Mn, Ni, Zn,
Pb and Sb; ten times as much Cu and Co; fifteen times as much W; and high Ag, As
and Sn. All these elements except W are typically high in weathered kimberlite.
The high W in the clay cuttings is probably contamination from the drill bits.


A very small piece of clay trapped in the core barrel between fragments of
quartz filled and coated vugs in dolomite may be representative of the clay
horizon. The composition of the clay is similar to the weathered lateritic
alkaline ultramafic rocks at Errabiddy in Australia. However, high SiO2 (67.4%)
in the clay is probably contamination by 1) quartz from vuggy dolomite that
trapped it in the core barrel, 2) quartz from the overlying till or 3) quartz
from marine sediments that would fill depressions above weathered kimberlite.
The most striking characteristic of the clay compared to the average less than
80 mesh till in the area is high Al, low Ca and Mg together with relatively high
LOI (loss on ignition), relatively high Ti, Nb, Cr, Li, V, As, Ce, Cs, Ga, Ge,
La, Lu, Pr, Rb, Sb, Ta, Th, U and very high Pb. Low Fe and related Mn and Ni are
unexpected because there is evidence of laterite weathering in the area.
However, the Fe, Mn and Ni values of the clay are similar to those of African
kimberlitic calcretes. The dolomite fragments that trapped the clay may have
provided a local calcrete environment.


The clay cuttings include very little of the clay. Much of the fine clay has
been lost and there has been considerable dilution of the cuttings by coarse
sand. Nevertheless, concentrates from the three holes that penetrated till and
ended in clay were submitted for kimberlite indicator mineral (KIM) analysis.
THD-3 contained no KIMs. THD-4 contained 6 chromites and one picroilmenite
(10.23% MgO; 3.24% Cr2O3) in the clay cuttings and 8 chromites in the overlying
till cuttings. The chromites lie on a relatively narrow compositional trend line
indicating a single population and one grain plots in the Argyle chromite field.
The clay cuttings of THD-4 contained notable galena. THD-5 contained one
picroilmenite (9.73% MgO; 0.39% Cr2O3) and a significant amount of sulphides in
the clay cuttings.


While the clay cuttings have lost fines and are contaminated by till and marine
sand they show many characteristics of weathered kimberlite including anomalous
numbers of locally derived KIMs in THD-4.


Project Summary

Talmora holds 211 mineral claims (68,784 acres) straddling the 68th parallel on
the east side of the Lena West diamond area of the Northwest Territories. Most
of the claims are in the Inuvialuit Settlement Region with the remainder in the
Sahtu Settlement Region.


Over $75 million has been spent in the Lena West area by other companies with
the recovery of numerous kimberlite indicator minerals (KIMs) and an
unprecedented 18 diamonds in field samples. No kimberlites have been found
except for the Darnley Bay and the Dharma kimberlites on a well-defined
favourable structure that includes the Talmora property.


Sampling on the Talmora property shows a strong correlation between KIMs in till
samples and magnetic anomalies with characteristics of kimberlite pipes. The
majority of Lena West KIMs (those west of Talmora) are very similar to those
from the Talmora property but differ from those of the Darnley Bay and Dharma
properties.


There is every reason to believe that the Talmora property may be the source of
the abundant KIMs and diamonds of the Lena West area. Talmora has many targets
ready for drilling.


The technical information contained in this press release was compiled by Alan
W. Davies, P.Eng., P.G., who is the Vice-President of Exploration for Talmora.
Alan W. Davies is a qualified person as defined by National Instrument 43-101.


CAUTIONARY STATEMENT

This News Release includes certain "forward-looking statements". All statements
other than statements of historical fact, included in this release, including,
without limitation, statements regarding potential mineralization and reserves,
exploration results, and future plans and objectives of Talmora, are
forward-looking statements that involve various risks and uncertainties. There
can be no assurance that such statements will prove to be accurate and actual
results and future events could differ materially from those anticipated in such
statements. Important factors that could cause actual results to differ
materially from Talmora's expectations are exploration risks detailed herein and
from time to time in the filings made by Talmora with securities regulators.


FOR FURTHER INFORMATION PLEASE CONTACT: 
Talmora Diamond Inc.
Raymond Davies
President & CEO
416-491-6771
416 499 5187 (FAX)
rayal.davies@sympatico.ca
www.talmoradiamond.com

Talmora Diamond (CSE:TAI)
Historical Stock Chart
Von Nov 2024 bis Dez 2024

Talmora Diamond (CSE:TAI)
Historical Stock Chart
Von Dez 2023 bis Dez 2024